My 1928 Dodge Victory Six
Project



1st pix taken the winter before the boys brought it to the house in 2001.  
 The ranger district told me it was on the property when they bought it in  1941 ! 
  


 In 2002 it showed up in my yard between the house and shop.



Ouuch, hope there is enough metal left to sand..

 

That rear fender I thought was a fixer upper,  considering what they wanted for one !!!!!!!!

I'm happier than a Tornado in a trailer park...



Hey, looks like there is a car under these dints....











The boxing of the frame and most of the body straightening and mustang
front suspension, motor and transmission mounts I put in,  in 2002.







In '03 I had that little bout with cancer.
 In '06 I started back at it. 
              In '07 , I hung the power brake unit and pedal.   Also chopped  3 and 1/2 inches off  the top and 
 the doors. I have a drivers door but it needs a lot of work before I can cut it down. 
I been working  on the brackets for the floor boards etc..   Also hung the foot feed !   A little wood work also, that's about  where we're at right now...

Here is some more pix, work'n the driver door.    Work'n on radiator bracket and support rods to fire-wall.

Some interior wood work

 Here's some more pix.   The crappy door after!!!!    And the steering mock-up.

 

Here is more pictures submitted 10-24-2010, Still working on her...

Above is the route the steering needed to take in order to get around the exhaust manifold.

Above is showing the 1/8'' - 1/2''  extra metal I welded in around windshield to give enough metal for the windshield rubber boot.

The tilt wheel assembly.

 Making a little more progress.   Floorboard work 11/28/2010 fabed from scatch.

Here is some more of the floorboard and  shift console work. 

Finished bottom close in on floorboard



The rest of the floorboard with battery well



The S.S. steel is a cover plate over the shifter



Hump with cover plate



This little item is a  bracket for the shift cable to run in